ATR Infos Safenet Model 330 | ATR Infos e-card

ATR Infos Telesec TCOS 2.0

		STUDY

The standard ATR of the Telesec TCOS 2. 0 based on the SLE 66CX 320P Chip of Infineon is: 3b ba 14 00 81 31 86 5d 00 64 05 14 02 02 31 80 90 00 91
(picture is showing a TCOS netkey Card)

TCOSmin V2.0.

ATR Bytes	Parameter
TS=0x3b (direct)	f(min)=1000kHz (default)
T0=0xba (Y(1)=11,K=10)	f(max)=5000kHz
TA(1)=0x14 (FI=1,DI=4)	Fi=372
TB(1)=0x00 (II=0,PI1=0)	Di=8
TD(1)=0x81 (Y(2)=8,T=1)	N=0 (default)
TD(2)=0x31 (Y(3)=3,T=1)	P=0dV
TA(3)=0x86 (IFSC=134)	I=25mA
TB(3)=0x5d (BWI=5,CWI=13)	X=Not supported (default)
T1=0x00	U=A only (default)
T2=0x64 'd'	IFSC=134
T3=0x05	BWI=5
T4=0x14	CWI=13
T5=0x02	EDC=LRC (default)
T6=0x02	T(supp)=1
T7=0x31 '1'
T8=0x80
T9=0x90
T10=0x00
TCK=0x91

Meaning of the Parameter

As seen above, the single bytes of the ATR indicate certain values.

f(min): minimum frequency for communication with the card
f(max): maximum frequency, for communication with the card
Fi: Clock rate conversion factor.
Di: Baude rate adjustment factor.
N: Extra guardtime
P: programming voltage
I: programming power
X: Clock stop indicator
U: Class indicator for operating condition. class A = 5V, class B = 3V
IFSC: Maximum information field size for cards; maximum length of blocks, the card can receive
BWI: Block waiting time integer. The maximum delay between rising (front) edge of the last character in a block to the rising (front) edge of the next block.
CWI: Character waiting time integer. The maximum delay between the rising (front) edges of to consecutive characters within a block.EDC: Error detection code. Gibt die Art der Error Detection (LRC, CRC) an.T: Protokoll Typ.

Conclusion

The performance results of a card reader depends strongly on the used smart card. To compute the etu (elementary time unit), the time length for transmittance of one bit, you need the frequency and the conversion and the adjustment factor. The formula is

1 etu = (F/D) * (1/f)

F = Clock rate conversion factor
D= Baud rate adjustment factor
f = Frequency (Hz)

Concretely the TCOS 2.0 card results in an etu about ap. 9ms (Fi = 372, Di = 8, f = 5 MHz). For the user more interesting is the baudrate of the communication with the card. You can compute it with:

Baudrate = (f/F) * D

The TCOS 2.0 has a maximum baudrate of 107526. This value is accepted by the card. Crucial is the frequency of the card reader - resulting in other baudrates. Due to this facts it is possible, that a card reader can communicate very fast with one card, while another card seems to be extremely slow. You can see this perception in your Reader Test.